cyclejohn cyclejohn is offline
|10:36 AM - 95ShadowACEGuy mentioned cyclejohn in post Fuel leak
Like cyclejohn stated, the OEM hose...
|06:05 PM - Sundown mentioned cyclejohn in post Gearing - Shaft - Annoying....
... thread posted by cyclejohn is the way to prove ...
|09:10 PM - Sundown mentioned cyclejohn in post Gearing - Shaft - Annoying....
...otal dismissal of cyclejohn. 's attempt to help....
|02:01 AM - lcann25 quoted cyclejohn in post 1984 VT750C Transmission issues
I had actually sat here for ab...
|02:00 PM - cyclejohn quoted lcann25 in post 1984 VT750C Transmission issues
I'm open to any advise I can...
|07:22 PM - cyclejohn quoted Mopar Maniac in post Engine Help
I was wondering if anyone knew wh...
|09:07 AM - cyclejohn quoted George Type-S in post What is this??
...set to off) Hey George Type-S, Could the torn bo...
|12:25 AM - George Type-S quoted cyclejohn in post What is this??
1) Yes 2) Yes The part you...
|09:24 AM - Damon78 quoted cyclejohn in post Fuel leak
The middle section of the tube...
|07:13 PM - cyclejohn quoted George Type-S in post What is this??
1) so it's ripped, is this going t...
|07:02 PM - cyclejohn quoted Damon78 in post Fuel leak
Going by the schematic on bi...
|03:07 PM - cyclejohn quoted phase in post Turn signal switch - waited too long
Any ideas would be appreci...
|08:50 PM - Scared quoted cyclejohn in post new bike problems
If the engine is running and d...
|08:44 PM - cyclejohn quoted Jeffd930 in post new bike problems
started to smoke and leaking ...
|08:31 PM - cyclejohn quoted Jeffd930 in post new bike problems
it would keep dying right aft...
|08:25 PM - cyclejohn quoted j35u5yo in post Testing coil packs
... coil is good Hey j35u5yo, An ohm reading be...
|02:02 PM - mikestp quoted cyclejohn in post RE=machining VT750 1983 culinder head
Yeah, don't dive in, lol. In...
|07:45 AM - cyclejohn quoted mikestp in post RE=machining VT750 1983 culinder head
I don't plan to do it like a...
|05:00 AM - mikestp quoted cyclejohn in post fantastic vids.... thanks
Hey Mikestp, I do not know w...
|12:59 PM - cyclejohn quoted Telemarshallman in post Rev limiter VT1100T
Does my bike even have a limiter? ...
|09:54 AM - cyclejohn quoted mikestp in post RE=machining VT750 1983 culinder head
...Any thoughts? Hey Mikestp, I do not know whi...
|07:02 PM - cyclejohn quoted mikemccloskey in post Carb Problems?
What now? What is the condition ...
|06:27 PM - cyclejohn quoted jpr1968 in post Clips for Neck Cover-Any Other Options?
You can use clip nuts and re...