Honda Shadow Forums banner

'84 vt700 clutch issues

1883 Views 8 Replies 5 Participants Last post by  Arby
Hey guys I was hoping someone would be able to help me. The problem I'm having is that I just replaced the slave cylinder on my clutch and I was bleeding it with a vacuum pump. Well I though I had bled it correctly and ran probably about half of the container of brake fluid. Anyway now when I squeeze the clutch lever it has tension and is definitely moving the piston in the slave cylinder but the clutch will not engage. The way I tested this was to put the bike into first then squeeze the clutch and try to move the back wheel with my hand and it won't budge. I'm not sure what's wrong, could it be because I have the bike off of the floor? I was just trying to see if you guys had any ideas. Also near the clutch lever there are two wires coming out and I'm not sure if that has anything to do with the clutch or not. I tried my above method with the bike turned on, but not running (I'm still working on that). Thanks guys.
1 - 1 of 9 Posts
Try bleeding it at the banjo fitting on the master cylinder.
1 - 1 of 9 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.