Honda Shadow Forums banner
1 - 1 of 1 Posts

·
Registered
Joined
·
107 Posts
Discussion Starter · #1 ·
hey guys
the plunger in the master cylinder of my clutch was leaking (bike would move while holding clutch lever for about 30 sec)
i bought a M/C rebuild kit and put it in, now i can hold in the clutch for a long time and bike will not move. but i keep getting air in the system
i put new crush washers on the banjo bolt going into the M/c but still getting air.
so my question is could that seal behind the clutch lever (on the plunger) let air in or is that strictly used to hold fluid inside the M/C?
i never had a problem with air getting in the system untill i put in the rebuild kit...

thanks!
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top