IF you`re talkin` about the "crossover tube" it ain`t too bad of project of 45 minutes...
I THINK there`s a sticky on it too...
I THINK there`s a sticky on it too...
Posts by "Captain D"
1 - 3 of 18 Posts
$600 Honda Buck$???
LLLL Bring it over, I`ll show you how to, for nothing!!!
Of course, you can leave a donation, if you feel so moved...
The 2000 is the same Bike as mine...
I did NOT have any issue with removing both clips, sliding the tube forward to install the rear "O ring" then sliding it rearward to install the front....
Lubrication was helpful in sliding the tube with new "O rings" though...
I made ""Special tool # 321678"" for installing the "O rings" onto the tube...
It consisted of two pieces of small gauge wire hooks, long enough to grab and maneuver the "O rings" into position...
Including Getting the bike onto the lift, reading the sticky and fabricating ""Special tool #321678"" = 45 minutes TOPS!
LLLL Bring it over, I`ll show you how to, for nothing!!!
Of course, you can leave a donation, if you feel so moved...
The 2000 is the same Bike as mine...
I did NOT have any issue with removing both clips, sliding the tube forward to install the rear "O ring" then sliding it rearward to install the front....
Lubrication was helpful in sliding the tube with new "O rings" though...
I made ""Special tool # 321678"" for installing the "O rings" onto the tube...
It consisted of two pieces of small gauge wire hooks, long enough to grab and maneuver the "O rings" into position...
Including Getting the bike onto the lift, reading the sticky and fabricating ""Special tool #321678"" = 45 minutes TOPS!
borings -= Probably got fumble thumbs like me...
Glad you got it fixed, even without my reply to your size question...
but to answer > Nope, I bought `em from Honda and didn`t worry about it...
Lets RIDE
Glad you got it fixed, even without my reply to your size question...
but to answer > Nope, I bought `em from Honda and didn`t worry about it...
Lets RIDE
1 - 3 of 18 Posts
