Honda Shadow Forums banner
1 - 1 of 5 Posts

· Registered
2 Posts
Discussion Starter · #1 ·
I went to my friendly Harbor Freight and got a bike lift for my 1998 Aero VT1100C3.

When I came home and put it under the bike I noticed that the bottom of the engine extends below the frame rails that when you go to lift the bike it rocks on the motor. So when I turn the jack90 degrees to keep the jack bars parallel to the frame rail the tire and fender are in the way of the jack handle and there is no way to jack it up.

Is there a jack made for these bikes I should be looking for or do I need to make something?

Thanks for any help

1 - 1 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.