Honda Shadow Forums banner
1 - 3 of 3 Posts

·
Registered
Joined
·
150 Posts
Discussion Starter · #1 ·
I just pulled it out of the box and from the looks of it the only way it stays on the bike is the tab that goes under the tank and the little screw that goes in the back into the fender? that does not seem like a lot to me, considering that the stock seat has two extra bolts that atach it to the frame...

and input would be nice.

Thanks in advance
 

·
Registered
Joined
·
144 Posts
Same here

I just got my corbin and it is the same way. Tab and one little rear fender screw. I have been looking at diffrent ways to secure it better. I am worried somebody might steal it. All you need is a small adjustable wrench and less than 2 minutes and it can be gone. :x
 

·
Registered
Joined
·
5,978 Posts
I've had my Corbin DT for 5yrs and never had a problem with it coming loose, just don't cram that back bolt cap down super tight or you'll pull it thru the fender, never worried about somebody stealing it, mine is protected by Smith-Weston or colt, don't think anyone would steal it.
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top