Honda Shadow Forums banner
1 - 1 of 1 Posts

· Registered
Joined
·
359 Posts
Discussion Starter · #1 ·
Has anybody found a way to stop the guide plug on the 1100 ACE from leaking? The O ring has been replaced before, then a rubber plug was wedged in between the case and frame, also it was covered in some kind of junk, thinking silicone based sealer. The plug started leaking a few years back, never enough to raise a concern. Until now. I know even in all the posts i have read on here that somebody has had to have tried something that worked. At the local Honda shop, one of the parts guys, he's a dirt bike guy, told me about the honda bond that they use to seal the case on dirt bikes. My concern is that they use a hammer and chisel to pop the cases open for rebuilds. So is there a reason not to seal it this way? Has anyone tried it?
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top