Honda Shadow Forums banner
1 - 3 of 3 Posts

·
Registered
Joined
·
6 Posts
Discussion Starter · #1 ·
Hi everyone, came on here looking for some guidance regarding my new bike! First cruiser for me, been riding enduro/dual sport for a long time. Pics below of my new bike, low milage (38km / 23.5mi), from the original owner, and got it for really cheap (family friend).

Wheel Tire Vehicle Fuel tank Automotive lighting
 

·
Registered
Joined
·
6 Posts
Discussion Starter · #3 ·
Welcome to the forum. Nice looking bike.

What do you need guidance with?

Eric


Sent from my iPhone using Tapatalk
Hi Eric, thank you for the warm welcome. I was hoping to find info on a couple topics, figured there would be some experienced folks around here that could help =)

1. Identification of the trim level for the model: VIN plate is stamped with Model VT750CD3 not sure which package this is. I've seen Ace, Aero, Sprit, Phantom, so not sure what category this falls into, or maybe it is just a base model...

2. Tank Restoration: The tank has a dent on the opposite side, the owner put the bullet hole sticker on the dent, and then mirrored it on the other side so it was symmetrical. Not sure how I should go about fixing the tank, because I want to pull those stickers off haha.

3. Specific Maintenance Items: Other than the typical greasing bearings, adjusting cables and whatnot; I was wondering if there are any items to specifically pay attention to.

Thank you in advance.
 

·
Registered
Joined
·
6 Posts
Discussion Starter · #11 ·
Hey everyone, apologies for the delay here, thank you to everyone who replied!

The glue dent puller looked so promising until he pulled an entire paint chip off lmao might be something to consider!

I've been trolling the mechanical fourms, lots to take in around here.

Thanks again...
 
1 - 3 of 3 Posts
Top