Honda Shadow Forums banner
1 - 1 of 1 Posts

·
Registered
Joined
·
2,530 Posts
The connector is under your seat. In order to get the wires from the back of the bike to the connector under your seat, you will have to remove the rear fender. It isn't a hard job, but you want to be careful with your fender so you don't scratch it.

To remove your fender, first remove your seat. Then take loose the rear 4 bolts on the fender rail. If you have a sissy bar, that will come off too. Once you have the fender loose, set it on the wheel. You will now be able to access the nut that holds the turn signal on and the wiring to the connectors.

Hope this helps.

Joe
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top