Upper Bolts for Engine Guard, 1100 T

670 Views 5 Replies 4 Participants Last post by megajohn, Apr 16, 2015

Labswine

Discussion Starter · Apr 4, 2015

I need to remount the factory engine guard on my 1100 T. The PO removed it and didn't save the bolts.

Anyone know whether the bolts are coarse or fine thread, what size and how long? I'll be getting stainless ones if available.

Much appreciated.

Save

1 - 3 of 6 Posts

Labswine

Discussion Starter · #3 · Apr 4, 2015

Well, the issue is that I'd have to take the bike to the place (not that that's an issue) and run in and out checking for the proper bolt and was hoping someone here knew to avoid that...

Save

Labswine

Discussion Starter · #5 · Apr 7, 2015

Then mine must be the Cobra because there are the two holes at the top that you mentioned for attachment. Thanks for the info.

Save

1 - 3 of 6 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.

Top Contributors this Month